> 11-20 of 21
New tool for use with the Centax-II bell housing. Made from spring steel and comes with pin to aid the application of the pinion gears.
Tool for mounting the rear upper wishbone pivot ball. Comes supplied with screw to aid mounting. Can be used for all Serpent cars.
Special tool to mount pinions on Centax clutch housing. Fits 15-16-17-18-19-20T pinions. Made of durable composite nylon.
The ultimate set up tool for tuning the Veteq. Because the Veteq chassis is in two pieces and the chassis surface is not completely flat, we have created these 3 posts which enable you to set your car level to measure droop more accurately.Made from aluminium these posts fit perfectly into the 3 mounting holes in the Veteq´s 2 chassis plates. The posts come with rubber o-rings which make placement into the chassis easier.Suitable for the Veteq and Vector NT.
Tool to mount hex. nuts to 2-speed drive flange and clutch bell. Made of durable composite nylon.
Handy tool to hold 2-speed gears during mounting. Fits all gears from 43 till 50T. Made of durable composite nylon.
Special tool to hold Centax clutch housing while mounting the pinions. Made of special steel.
Anodised aluminium tool to aid correct assembly of the RCC shock absorber.
Anodised aluminium Centax endplay tool. Also can be used to hold the flywheel from rotating when tightening the flywheel nut. Check www.Xceedrc.com